the data bank is READ-ONLY. Use the following command to enable READ-WRITE access:
Note that files errors, plots, reports and batchout should also have READ-WRITE access. See Question 6.2.6.
6.2.4: Why do I get the message:
The binary of the module you are trying to start is probably corrupt. See Question 2.0.4.
6.2.5: Why do I get the message:
See the answer to this question in the archived FAQs.
6.2.6: Why do I get the message:
EMME/2 generates the ERR* IO - 30... message when at least one of the files (errors, reports, plots, etc., or any file name defined in the flexible file naming system) used by EMME/2 has READ-ONLY permission. EMME/2 requires these files to have READ/WRITE access. It is possible to correct the situation by using the DOS command attrib -r in the data bank directory. This will change all file permissions.
6.2.7: Why do I get the message:
