EMME/2常见问题解答1：General Information

  uage: access to project title and scenario title from within macros; access to matrix names and descriptions for all matrix types; append to an existing macro; read external files from within macros; generate graphical input sequences from within macros

For more details, refer to the documents EMME/2 Release Notes - Release 9 and Supplementary Release Notes - EMME/2 Release 9.5.

1.0.4: What problems have been discovered since Release 9.0?

A list of the bugs found and corrected since Release 9 can be found in the document entitLED Supplementary Release Notes - EMME/2 Release 9.5.

1.0.5: Is it possible to use a data bank created with (or updated for) Release N with Release N-1?

NO! Releases are upward compatible but, once updated, a data bank cannot be used with prior releases. Note that this applies to major releases only, that is, no update is needed between intermediate releases (for example, between 8.0 and 8.4) and therefore, there are no compatibility problems between intermediate releases.

1.0.6: On what platforms is EMME/2 supported?

The computing platforms on which EMME/2 is currently supported are listed in the products section entitLED System Requirements.

1.0.7: What is the minimum equipment needed to run EMME/2?

• For PCs the minimum requirements are:
  • SVGA graphic adapter supporting the VESA standard
  • Sufficient hard disk space for your data bank (maximum data bank size: 2 or 4 Gigabytes, depending on the operating system)
  • Enough memory to load the largest module. The amount of memory required depends on the licence size (Mb=Megabytes):

    Size (number of zones) Minimum required Recommended for
    better performance

    上一页  [1] [2] [3] [4] 下一页